Patio heaters are famous for one reason: they allow you to enjoy your outdoor living spaces throughout the cooler months. We don't need to go back inside because it's becoming calm in the evening. However, the process to light a patio heater manually may appear a bit to be a more complicated process. Now we'll discuss how to Light Patio Heater Manually??
All you have to ensure to light a patio heater manually with a trial ignition system is to push and go with the control knob and then push the stick button a few times. To light a patio heater manually without a pilot ignition mechanism, you must also consider the gas control knob.
This article will go over these processes in further detail. But, before we get there, there's something significant to discuss: the conservative measures you should take before attempting to light a patio heater manually.
While you may be concerned that your heater is malfunctioning, you do not need to be worried. You're set to go as long as you know how to light a patio heater manually. Follow the three simple steps listed below to learn a new skill that will come in handy when you go camping and need to light up a portable camping gas burner.
A few Steps to Light a Patio Heater Manually
1. Turn the Control Knob.
To begin, go with the control knob to the pilot position. It should be the same as turning the knob on your gas stove. In general, it is 45 degrees anti-clockwise. If in doubt, consult the owner's manual for your patio heater.
2. Have you turned it on?
If the patio heater does not light up after consistently pressing the control knob for a while, you must use a lighter to ignite it. Use a candle lighter to avoid burning your finger. Before lighting the candle lighter, insert the lighter via the match lighting hole.
3. Set the Knob to High.
Finally, remove your finger from the control know and allow it to release naturally. Then, depending on your heater's setting and heating choice, move the control knob 45 degrees or less to increase the size of the flame.
Before turning on your gas patio heaters, ensure there are no flammable or combustible things nearby and that the gas tank/ propane tank is attached correctly.
4. Take the Precautions
Before turning on your patio heater, you need to take a few measures. While the patio heater emits heat and glows red, it is fueled by fire. There must be no combustible items nearby, or they can catch fire. Here are a few safety measures and beginner's advice to keep in mind before igniting a patio heater.
Also, make sure you have enough space around your patio heater and that if it is undercover, there is still enough space around it for it to work within its given dimensions.
The First Thing to Keep in Mind is the Gas Regulator.
It is the device that regulates gas flow in your patio heater, preventing gas from seeping out while it's not in use. Remember to turn off the regulator when you've finished using the heater. Follow the patio heater lighting instructions.
Always be on the Lookout for Gas Leaks.
If you notice a gas odor when you turn on the regulator, it is most likely due to a leak in the gas delivery pipe. When gas flows through a tube that does not leak, it makes a specific sound. If you find any anomalies in your gas pipe, you should have it replaced as soon as possible.
Keep any combustible or flammable materials away from your patio heater. Paper, plastic, wood, and other easily flammable materials are examples.
Keep your patio heater clean. The gas supply line should not be obstructed to ensure an even flow of gas.
Make Sure the Gas Tank is Filled.
Lift the base of the propane patio heater to check if the tank is full. It is an excellent beginner's tip that will ensure the heater lasts as long as you intend to use it. A tank that isn't full may run out of fuel after a time, cutting your outside activities short.
Easy Troubleshooting
One of the most acceptable ways to enjoy the outdoors without being concerned about the cold weather is to use a patio heater. Previously only found in restaurants, they are now a household need for most individuals. However, if it refuses to start automatically, it might soon disrupt your life. You will have to start it manually in this scenario.
Turn the control knob to the left to manually light your patio heater. Hold it for 45 seconds before pressing the stick button below while still holding the knob. When the pilot light is ignited, release the knob and turn it to the appropriate position. If this fails, place a long candle lighter through the pilot hole.
When lighting the heater, you should always proceed with caution. The first thing you should do is make sure it isn't too close to any combustible or explosive materials that could cause an accident. Aside from that, before starting an open flame, make sure you have enough space between it and a wall or roof.
How to Use the Pilot Ignition System to Light a Patio Heater
To ensure uniform dispersion of heat, keep the burner clear. Take it out and look for anything that could cause a blockage to inspect it for any anomalies. It must always be done when the patio heater is turned off, as you do not want to endanger the fire.
An inlet beneath the burner allows gas to mingle with air. This section should also be free of air and have no obstructions. The patio heater gas regulator serves as a guide to managing the heat of the patio heater.
Make sure to follow the gas regulator as specified on the labels. The regulator connects the gas supply pipe and carrier to the burner.
Always check that the regulator is in good working order; you don't want a problem with it. Some feature switches enable you to make the gas control knob depressed, preventing the cylinder from being depressed.
The bug screen should be kept clear at all times. It will ensure that your flame is clean and insect-free. The screen is a deterrent to insects drawn to light, keeping them away from the roast. When cleaning, remove the bug screen and thoroughly wash and dry it. It should be done as frequently as possible to avoid having a terrible stain on it.
The ignition system is integrated into the gas control valve system. Turn on the ignition system clockwise, and then perform the following:
- Push the control knob into position and hold it there for 45 seconds. It will start a pilot flame and allow it to pass through the 12" match lighting hole.
- Keep your grip on the knob. Instead, hit the stick button 4-5 times. If that doesn't work, use a long candle lighter to avoid getting too close to the flame.
- Now that you have your flame flip the knob to high on the recommended degree that you may wish to consider the space you have.
How to Light a Patio Heater without a Pilot Light?
- To begin, verify that the liquefied gas tank is entirely closed.
- Attach the tank and slowly open it until it is fully open for optimal patio heater gas utilization.
- Third, depress the gas control knob, turn it to the low position, and hold it there. Then, 3-4 times, hit the ignition. If it doesn't light, use a long candle lighter to light it. To understand how to light a patio heater using a lighter, you may need to refer to the instructions that came with the lighter.
- Keep the gas knob depressed so that the gas continues to flow normally.
- Finally, release the gas knob and turn it to the desired high or low setting that takes into account.
Where Can You Buy a Manual-lighting Patio Heater?
You may get your patio heater at any home improvement store or online like from Lausiant.com. You will be able to light any patio heater you purchase manually, but you should double-check to see whether it has an automatic ignition if that is a feature you want. Before using your patio heater, thoroughly read the instruction booklet.
Conclusion
Patio heaters improve the quality of life in the modern era. It allows us to enjoy the chilly outdoor weather without dealing with the big freeze. We live in a technologically advanced age in history; everything is automated, and we are even getting closer to a future of self-driving cars.